![]() ![]() ![]() Check Programs and Features to ensure that Datto Windows Agent appears as an installed program.Make sure the production machine reboots following the installation of the Datto Windows Agent. ![]() Follow these steps to confirm that the installation was successful: The Datto Windows Agent does not have a GUI. If the installer is unable to install the necessary certificates, ensure that the Group Policy is not set to "Allow only Enterprise Administrators" Verifying the installation After you restart the production machine, pair the endpoint with your Datto appliance to begin taking backups. If you do not schedule the protected system's next backup to be a differential merge, the first snapshot it captures following reinstallation of the Datto Windows Agent will be a full backup.Ĥ. If you are reinstalling the Datto Windows Agent after previously uninstalling it, use the Force a Differential Merge feature on your Datto appliance to re-associate the backup increments for the protected system. When the installer completes, you must reboot the production machine to finalize the installation of the agent.ģ. You must have internet access both during the install and during the first start of the agent so that the software can retrieve certificates.Ģ. Proceed to the Setup section of this article. Download the agent software from the following link: Datto Windows Agent: Legacy Installer.Ģ. Download the agent software for version 2.8.XĢ. For Windows Vista and Windows Server 2008ġ. Navigate to and click the Windows icon in the Backup Agent Download category.ģ. Download the agent software from the Datto Downloads page. Installation For Windows Server 2008 R2 and Aboveġ. Versions 2.1 to 2.8 of the Datto Windows Agent require Windows Vista, Windows Server 2008, or newer.įor complete pre-deployment requirements for your version of DWA, ,be sure to review Getting started with the Datto Windows AgentĪnti-Virus software can interfere with installation and should be temporarily disabled prior to installing the Datto Windows Agent. The newest DWA Version (3.0 and above) requires Windows Server 2008 R2 Service Pack 1 or newer. This article assumes that you have reviewed both the SIRIS, ALTO and NAS: BCDR networking and bandwidth requirements and the Getting started with the Datto Windows Agent articles and that your production environment meets the configurations described in both resources. Setting schedules / Initial configurations.This article describes the GUI-based installation process for the Datto Windows Agent.įor silent installation instructions, see Performing A Silent Install Of The Datto Windows Agent (Version 2.0) or Performing A Silent Install Of The Datto Windows Agent (Version 2.1 And Above).įor RMM deployment instructions, see Deploying the Datto Windows Agent (Version 2.0) via Datto RMM or Deploying the Datto Windows Agent (Version 2.1) via Datto RMM. ![]()
0 Comments
Leave a Reply. |